Product Data Sheet Show all documents

SikaBond® DV PK

Economical Water-Resistant Bonding Agent And Mortar Admixture

SikaBond® DV PK is a synthetic emulsion that is used as admixture for cementitious bonding bridges and high quality site-mix mortars. Suitable for use in hot and tropical climatic conditions

SikaBond® DV is simply added to the mixing water to improve the following properties:
  • adhesion
  • shrinkage
  • water resistance
  • abrasion resistance
  • chemical resistance
SikaBond® DV is non-corrosive, ready to use and does not re-emulsify, even under highly alkaline conditions.
Find a Store
Product Data Sheet Show all documents

Usage

SikaBond® DV is used as bonding agent and site-mix mortar admixture for the following applications:
  • Thin layer patching mortars
  • Renders
  • Floor screeds
  • Concrete repair mortars
  • Abrasion resistant linings
  • Tile fixing mortars
  • Masonry mortars
  • Bonding slurry for fresh to old concrete  

Advantages

SikaBond® DV is simply added to the mixing water to improve the following properties:
  • adhesion
  • shrinkage
  • water resistance
  • abrasion resistance
  • chemical resistance
SikaBond® DV is non-corrosive, ready to use and does not re-emulsify, even under highly alkaline conditions.

Packaging

05 ltr jerry can

20 ltr plastic can

200 ltr drum

1000 ltr IBC

Bulk supply in tanker is possible on demand

Colour

White liquid

Product Details

Product Information

Chemical Base

Acrylic dispersion 

Shelf Life

12 months minimum from production date if stored properly in original unopened packaging.

Storage Conditions

The product must be stored properly in undamaged, unopened original sealed packaging in dry conditions at temperatures between +5° C and +35° C. Protect from direct sunlight and frost.

pH-Value

≥ 5

Total Chloride Ion Content

Nil (EN 934-2)

Specific gravity

1.00 ± 0.02

Application

Application Information

DISPENSING

SikaBond® DV PK is generally added to the clean mixing water within the range 1 : 1 to 1 : 2. For all applica[1]tions, apart from sprayed on renders, a bonding slurry should be applied. Subsequent mortar application must be carried out whilst the bonding coat is still wet.
Application steps

MIXING

BONDING SLURRY

SikaBond® DV : Water = 1 : 1

Mix together with fresh cement and fine sand to a homogeneous brushable slurry consistency. The resulting bonding slurry should be brushed well onto the prepared surface.

MORTARS AND RENDERS

Mixing can be done in any suitable concrete mixer, such as a pan mixer. First add the cement and aggregate into the mixer and mix to a uniform consistency.

Then add the required quantity of diluted SikaBond® DV PK and mix slowly for at least 2 minutes. Apply by steel trowel and finish with a wooden float.

Documents